2024-01-14 HZST Clear PETG
- Temp Tower 230 or 235 is best for stringing, still adhered at 230. Stringing was pretty constant, although little.
- The extrusion parameters were near zero on pass 1 and 2
- Pressure advance was best at .08 about half way up. It might be a bit more,but not much.
2025-05-17 Accelaration Control
- In console on Mainsail use SET_VELOCITY_LIMIT to check machine limits.
- Stock V3 acceleration seems to be 500. https://www.youtube.com/watch?v=I5ezWTIumoQ
- Prusa
- In Prusa under speed you can find accelaration.
- I am not unsure how to specify only y acceleration in Prusa you might be able to do this in the config file on Mainsail printer.cfg .
- Changing the Default acceleration in Prusa to "300" inserts M204 S300 just before the body of the print. It might be smart to insert this before the homing starts maybe.
2025-06-17 Acceleration Tests in folder
- 500
- At 500m/s**2 estimated prusa time is 59 minutes. At start Klipper estimated about 1hr20min. Actual time was 1:05 . Print is marked 500, looks great.
- Klipper says 500 on Mainsail Dashboard. GCODE includes M204 S500 . Prusa Speed Default Acceleration 500. Prusa Machine limits say 500. If you set Y Acceleration in machine limits to 200 you get 1hr 4 estimate of print time.
